Banglalion Modem Running on NanoPi Neo

Recently I got a Nanopi Neo with Allwinner H3 SoC, 512MB RAM, 1 USB-A port and 1 Ethernet port. I am using Armbian as OS which is based on Debian.

I did a test if it was possible to run Banglalion WiMAX devices on this platform. So I grabbed Beceem WiMAX API sources and built it using gcc-linaro-5.2-2015.11-2-x86_64_arm-linux-gnueabihf toolchain.

First I had to build the Armbian kernel with Staging > BCM_WIMAX module. Then I dumped the image into a microsd card, put it into my NanoPi Neo and booted up.

I wasn’t sure which IP it got, so I ran nmap to find it out.

root@minhaz-desktop:~# nmap -sn 10.42.0.1/24
Starting Nmap 6.40 ( http://nmap.org ) at 2016-08-07 01:10 BDT
Nmap scan report for 10.42.0.28
Host is up (0.00027s latency).
MAC Address: 46:A0:87:0F:06:B6 (Unknown)
Nmap scan report for 10.42.0.1
Host is up.
Nmap done: 256 IP addresses (2 hosts up) scanned in 19.06 seconds

Then I logged into it. Checked its memory and CPU information.

root@nanopineo:/# free -m
             total       used       free     shared    buffers     cached
Mem:           495         90        404          8          5         43
-/+ buffers/cache:         42        453
Swap:            0          0          0
root@nanopineo:/# nproc 
4
root@nanopineo:/# lscpu 
Architecture:          armv7l
Byte Order:            Little Endian
CPU(s):                4
On-line CPU(s) list:   0-3
Thread(s) per core:    1
Core(s) per socket:    4
Socket(s):             1
CPU max MHz:           1200.0000
CPU min MHz:           480.0000

I built the necessary library, daemons, clients etc which can be found at minhazul-haque/beceem-cscm-armv7. Let’s install them.

Now let’s run the total setup.

Here is a photo of my little buddy and the Bilai modem.

Banglalion Modem on ARM

If you have any questions, ask below or open issue at the github repository.